![]() Please read website Cookie, Privacy, and Disclamers by clicking HERE. (Note: the stub will be drawn into the rope once it is loaded up.) With a second strand, leaving the third strand as is.Ĭut and melt the ends of the working strands, leaving a stub approximately as long as the diameter of the working strand. If you are making a tapered splice make two additional tucks with one strand and one additional tuck ![]() (note: after each set of tucks, pull all three working strands snug) Step #5 Tapered Splice If performing a standard splice skip this next step / go to step #6 Finishing the Splice: Should go over a strand then tucked under a strand. Perform four more sets of tucks for each of the three working strands. (note: the two temporary tape marks should be aligning and forming your eye.) (Note: It is easier to do this if you first turn the rope over, as shown in photo) ![]() Take the right strand and tuck it under the strand just to the right of the one you raised for tucking the middle strand. (note: the left strand should look like it is going over the strand you raised in the previous step) Take the left strand and tuck it under the strand just to the left of the one you raised on the previous step. (note: if this is your first time splicing, mark the strand you tucked under as this will be your reference point.) Tuck the middle strand under a strand on the standing part of the rope just beyond the taped mark. (note: if this is your first time splicing mark the ends of the working strands with an L â€"left, M â€"middle, and R â€"right.) To splice into a thimble with ears, shackle, or similar item, simply follow the directions of the splicing instructions, using the thimble or shackle bale to. Middle working strands across the rope just below the taped mark. Lay the strands out such that you have a left, middle, and right working strand. (note: bend following the natural bend of the rope so as not to put any twist into the eye or the splice.) Step #3 The First Set of Tucks This isĭone with the standing part of the rope in front of you, bending the tail of the rope from (note: be careful that the strands do not untwist) Step #2 Forming the eyeīend the rope to form the desired eye size and mark with a temporary wrap of tape. Heat seal or tape the end of each individual working strands. Mark this location with a temporary wrap of tape around the rope. Measure 14 crowns (or twists) from the end of the line. Three Strand Eye Splice (both standard & tapered) Step #1 â€" Beginning the Splice
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |